布袋除塵器除塵系統按照除塵器和通風機在流程中的相對位置，可以分為負壓除塵系統和正壓除塵系統。那布袋除塵器的這兩種系統有什么區別呢？

The bag filter dust removal system can be divided into negative pressure dust removal system and positive pressure dust removal system according to the relative position of the dust collector and the ventilation fan in the process. What is the difference between these two systems of bag filter?

（1） 布袋除塵器負壓除塵系統

(1) Bag filter negative pressure dust removal system

負壓除塵系統中，除塵器設置在通風機之前（負壓段或吸人段）。其特點如下所述：

In the negative pressure dust removal system, the dust collector is set before the ventilation fan (negative pressure section or suction section). Its characteristics are as follows:

① 由于除塵器設置在通風機之前，流過通風機的氣體已經過除塵，含塵濃度低，通風機受磨損大大減低，運行壽命長，處理初濃度高的含塵氣體時，一般采用負壓除塵系統。

① Due to the fact that the dust collector is installed before the ventilation fan, the gas flowing through the ventilation fan has already undergone dust removal, resulting in a low dust concentration and greatly reduced wear and tear on the ventilation fan. With a long operating life, a negative pressure dust removal system is generally used when dealing with high initial concentration dust containing gases.

② 除塵器和管道處于通風機的負壓段，容易吸入空氣，產生漏風。負壓除塵系統的漏風率為5%～10%，加大了通風機的風量，增加了電耗。

② The dust collector and pipeline are located in the negative pressure section of the ventilation fan, which is prone to inhaling air and causing air leakage. The air leakage rate of the negative pressure dust removal system is 5% to 10%, which increases the air volume of the ventilation fan and increases power consumption.

③ 在負壓除塵系統設計中應采用措施盡可能減少除塵器和管道的漏風，以保除塵器的良好運行。

③ In the design of negative pressure dust removal systems, measures should be taken to minimize air leakage from the dust collector and pipelines as much as possible to ensure the good operation of the dust collector.

（2） 布袋除塵器正壓除塵系統

(2) Positive pressure dust removal system of bag filter

正壓除塵系統中，除塵器設置在通風機之后（正壓段或壓出段）。其特點如下所述：

In a positive pressure dust removal system, the dust collector is installed after the ventilation fan (positive pressure section or extrusion section). Its characteristics are as follows:

① 由于流過通風機的含塵氣體未經除塵器凈化，通風機的葉輪和機殼易遭粉塵磨損。因此，正壓除塵系統只適于在氣體含塵濃度3g/m3以下、粉塵磨琢性弱、粉塵粒度小的條件下使用。

① Due to the untreated dust containing gas flowing through the ventilation fan, the impeller and casing of the fan are susceptible to dust abrasion. Therefore, the positive pressure dust removal system is only suitable for use under conditions where the gas dust concentration is below 3g/m3, the dust abrasion is weak, and the dust particle size is small.

② 除塵器處于通風機的正壓段．不必考慮除塵器的漏風附加率，通風機電耗較低。

② The dust collector is located in the positive pressure section of the ventilation fan. There is no need to consider the additional air leakage rate of the dust collector, and the power consumption of the ventilation fan is relatively low.

③ 除塵器的圍護結構簡單，如正壓袋式除塵器的圍護結構不需要密封，只要防雨即可；設備制造，安裝簡便，造價低。

③ The enclosure structure of a dust collector is simple, such as the enclosure structure of a positive pressure bag filter, which does not need to be sealed and only needs to be rainproof; Equipment manufacturing, easy installation, and low cost.

④ 布袋除塵器正壓除塵系統中，凈化后的氣體直接由除塵器排入大氣，可不設煙囪；除塵器有一定的消聲作用，通風機出口側可不設消聲器；有利節約除塵系統占地和初期投資。

④ In the positive pressure dust removal system of the bag filter, the purified gas is directly discharged into the atmosphere through the filter, and there is no need to install a chimney; The dust collector has a certain noise reduction effect, and there is no need to install a muffler on the outlet side of the ventilation fan; Beneficial for saving dust removal system land and initial investment.

單機除塵器設備使用正壓或者負壓的區別

The difference between using positive pressure or negative pressure in a single dust collector equipment

購買單機除塵器設備或者其他類型的袋式除塵器設備的時候，很多的朋友都會問：你們采用的是正壓方式還是負壓的方式？其實除塵器設備無論使用正壓和負壓都是沒有問題的。不過是在條件允許的情況下進行合理設計就好。

When purchasing standalone dust collector equipment or other types of bag filter equipment, many friends will ask: Do you use positive pressure or negative pressure? In fact, the dust collector equipment has no problem using both positive and negative pressure. Just design it reasonably if conditions permit.

下面詳細的給您介紹下關于單機除塵器設備使用正壓或者負壓的區別？工作條件下都有哪些的好處和壞處？

Below is a detailed introduction to the difference between using positive pressure or negative pressure in a single dust collector equipment? What are the benefits and drawbacks of working conditions?

1、單機除塵器在凈化粉塵的時候含塵氣流進入濾袋的方向有向外式和向內式。前者含塵氣流進入濾袋內部，由內向外過濾，粉塵積于濾袋內表面。

1. When purifying dust, the direction of the dusty airflow entering the filter bag in a single dust collector can be outward or inward. The former dusty airflow first enters the interior of the filter bag and is filtered from the inside out, causing dust to accumulate on the inner surface of the filter bag.

向外式的濾袋外部為干凈氣體側，便于檢查和換袋。

The outward facing filter bag has a clean gas side for easy inspection and bag replacement.

向內式的含塵氣流由濾袋外部通過濾料進入濾袋內，凈化后的氣體由袋內排出。向內式適用于脈沖噴吹和高壓氣流反吹的布袋式除塵器。

The inward type dusty airflow enters the filter bag through the filter material from the outside, and the purified gas is discharged from the inside of the bag. Inward type is suitable for bag type dust collectors with pulse blowing and high-pressure airflow back blowing.

2、負壓的除塵系統中風機置于除塵器的后面，使除塵器處于負壓，含塵氣流被吸入除塵器中進行凈化。這種方式的特點是進入風機的氣流是已經凈化的氣流可以防止風機被磨損。

2. The fan in the negative pressure dust removal system is placed behind the dust collector to maintain negative pressure, and the dusty airflow is sucked into the dust collector for purification. The characteristic of this method is that the airflow entering the fan is already purified, which can prevent the fan from being worn out.

正壓式的除塵系統中風機置于除塵器的前面，除塵器在正壓下工作。正壓式的特點是管道布置緊湊，對外殼結構的強度要求不高，但風機易磨損，不適用于濃度高，顆粒粗，硬度大，磨損性強的粉塵。

The fan in the positive pressure dust removal system is placed in front of the dust collector, and the dust collector works under positive pressure. The characteristic of positive pressure is that the pipeline layout is compact, and the strength requirements for the shell structure are not high. However, the fan is prone to wear and is not suitable for dust with high concentration, coarse particles, high hardness, and strong wear.

單機除塵器正壓和負壓使用的區別濾袋形狀有圓袋和扁袋。前者結構簡單，便于清灰。后者占空間小，單位體積內所布置的過濾面積大;但結構和清灰較復雜，換袋困難，濾袋與骨架的磨損較大。因此工業中大多采用圓袋。

The difference between positive pressure and negative pressure in a single dust collector is that the filter bag shapes include round bags and flat bags. The former has a simple structure and is easy to clean. The latter occupies less space and has a larger filtering area arranged per unit volume; But the structure and dust removal are complex, making it difficult to replace the bag, and the wear of the filter bag and the skeleton is significant. Therefore, circular bags are mostly used in industry.

本文由山東負壓組合友情奉獻.更多有關的知識請點擊:http://www.skycns.org.cn/真誠的態度.為您提供為的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

This article is a friendly contribution from Shandong Negative Pressure Combination. For more related knowledge, please click: http://www.skycns.org.cn/ Sincere attitude. We provide you with excellent service. We will gradually contribute more knowledge to you. Please stay tuned