脈沖除塵器簡介：

　　Introduction to pulse dust collector:

　　脈沖除塵器是在袋式除塵器的基礎上改進的新型脈沖除塵器，綜合了分室反吹各種脈沖噴吹除塵器的優點，克服了分室清灰強度不夠，進出風分布不均等缺點，擴大了應用范圍。

　　Pulse dust collector is a new type of pulse dust collector that is improved on the basis of bag dust collector. It combines the advantages of various pulse jet dust collectors with chamber backflow, overcomes the shortcomings of insufficient cleaning intensity and uneven distribution of inlet and outlet air in the chamber, and expands the application range.

　　脈沖除塵器工作原理：

　　Working principle of pulse dust collector:

　　脈沖除塵器是當含塵氣體由進風口進入除塵器，碰到進出風口中間的斜板及擋板，氣流便轉向流入灰斗，同時氣流速度放慢，由于慣性作用，使氣體中粗顆粒粉塵直接流入灰斗。起預收塵的作用，進入灰斗的氣流隨后折而向上通過內部裝有金屬骨架的濾袋粉塵被捕集在濾袋的外表面，凈化后的氣體進入濾袋室上部清潔室，匯集到出風口排出，含塵氣體通過濾袋凈化的過程中

　　Pulse dust collector is a dust containing gas that enters the dust collector through the air inlet. When it first touches the inclined plate and baffle in the middle of the air inlet and outlet, the airflow turns to flow into the ash hopper. At the same time, the airflow speed slows down, and due to the inertia effect, the coarse dust particles in the gas directly flow into the ash hopper. It serves as a pre dust collector, where the airflow entering the ash hopper is then folded upwards and captured on the outer surface of the filter bag through the filter bag with a metal skeleton inside. The purified gas enters the upper cleaning room of the filter bag room and is collected at the air outlet for discharge. The dusty gas is purified through the filter bag during the purification process

　　隨著時間的增加而積附在濾袋上的粉塵越來越多，增加濾袋阻力，致使處理風量逐漸減少，為正常工作，要控制阻力在一定范圍內（140--170毫米水柱），一旦超過范圍必須對濾袋進行清灰，清灰時由脈沖控制儀順序觸發各控制閥開啟脈沖閥，氣包內的壓縮空氣由噴吹管各孔經文氏管?chē)娚涞礁飨鄳臑V袋內，濾袋瞬間急劇膨脹，使積附在濾袋表面的粉塵脫落，濾袋恢復初始狀態。清下粉塵落入灰斗，經排灰系統排出機體。由此使積附在濾袋上的粉塵周期地脈沖噴吹清灰，使凈化氣體正常通過，保證除塵系統運行。

　　With the increase of time, more and more dust accumulates on the filter bag, increasing the resistance of the filter bag, causing the processing air volume to gradually decrease. In order to work normally, it is necessary to control the resistance within a certain range (140-170 millimeters of water column). Once it exceeds the range, the filter bag must be cleaned. During cleaning, the pulse control instrument sequentially triggers each control valve to open the pulse valve, and the compressed air in the air bag is sprayed into the corresponding filter bags through the Venturi tube through each hole of the blowing pipe. The filter bag instantly expands rapidly, causing the dust accumulated on the surface of the filter bag to fall off, and the filter bag returns to its initial state. Dust is cleared and falls into the ash hopper, which is then discharged from the body through the ash discharge system. As a result, the dust accumulated on the filter bag is periodically pulse sprayed to clean the dust, allowing the purified gas to pass through normally and ensuring the operation of the dust removal system.

　　本文由 脈沖除塵器 友情奉獻.更多有關的知識請點擊   http://www.skycns.org.cn  真誠的態度.為您提供為的服務.更多有關的知識我們將會(huì )陸續向大家奉獻.敬請期待.

　　This article is a friendly contribution from the pulse dust collector. For more related knowledge, please click http://www.skycns.org.cn Sincere attitude. We will provide you with comprehensive service. We will gradually contribute more relevant knowledge to everyone. Stay tuned