The excellent performance of the rotary feeder and its current widespread application have led to more customers in the market favoring the feeder. Exploring the outstanding role of this equipment in the environmental protection industry is undoubtedly beneficial for us to better produce. The structural design of the feeder is reasonable and scientific, so daily maintenance is also very convenient. But over time, there may also be some problems, such as oil leakage after refueling during maintenance. Let's understand: due to the excessive use of lubricating grease, it will leak from the output shaft, which does not affect use. However, the gearbox is already filled with oil when it leaves the factory. If there is not much leakage, a slight leakage will not affect use, and there is no need to worry about oil leakage and equipment damage. Of course, oil leakage may be due to the presence of air holes and sand holes in the casting itself, which is unlikely to occur, or damage to the sealing rubber ring.

旋轉供料器工作時，有時候會(huì )出現供料器軸承發熱的情況，原因如下：旋轉供料器旋轉不暢的各項原因均能導致發熱，應分別處理：內有雜質，要及時清理。軸的裝配間隙過小，也會(huì )造成軸承發熱，重新加以調整修配。工作環境溫度過高、油箱容積小、散熱不良，都會(huì )使軸承發熱。

When the rotary feeder is working, sometimes there may be heating of the feeder bearing. The reasons are as follows: various reasons for poor rotation of the rotary feeder can cause heating, and they should be treated separately: impurities inside should be cleaned in a timely manner. If the assembly clearance of the shaft is too small, it can also cause the bearing to heat up, so it needs to be adjusted and repaired again. High working environment temperature, small oil tank volume, and poor heat dissipation can all cause bearing heating.

直連式供料器與電動機聯軸器的同軸度差，同軸度應保證在0.1mm以?xún)?，現供料器大都采用鏈條式傳動。旋轉供料器內零件沒有消磁。裝配前所有零件必須消磁處理。還有就是裝配有誤都會(huì )造成。

The coaxiality between the directly connected feeder and the motor coupling is poor, and the coaxiality should be ensured to be within 0.1mm. Currently, most feeders use chain transmission. The parts inside the rotating feeder are not demagnetized. All parts must be demagnetized before assembly. Also, incorrect assembly can cause problems.